High Access
High Dusting Services in Texas
Dust on overhead structure eventually lands on product, equipment and floors. High dusting removes it at the source instead of chasing it below.
Tell us about the facility, its current condition and the work that needs to be completed.
Overview
What this service is
We work top down, capture what we remove where the environment calls for it, and protect what is underneath.
Scope
What may be included
Structural steel
Joists, beams, bracing and deck underside.
Mechanical
Duct exteriors, conduit, cable tray and piping.
Lighting and sprinkler
Fixtures, sprinkler lines and heads, cleaned without disturbing them.
Upper walls
Wall surfaces above normal reach.
Protection
Equipment and product covered or moved before work begins.
Cleanup below
Floor cleaning after overhead work is complete.
Planning
How it gets scoped
High-access cleaning projects may incorporate lifts or other access equipment when required by the scope. Floor condition, aisle width and ceiling height determine what can be used.
Site-specific safety requirements are reviewed during project planning and mobilization.
Overview
Removing dust at the source instead of below it
High dusting is the removal of accumulated dust from everything above normal reach: joists, deck, beams, duct exteriors, conduit, cable tray, sprinkler lines, light fixtures and upper walls. In a warehouse it protects product and light levels. In a plant it keeps residue off equipment and out of the process.
Work is always top down. Overhead comes first, the floor is cleaned last, and anything below is covered or moved before we start.
Triggers
Signs a building is overdue
- Visible dust bridging or hanging from joists and sprinkler lines.
- Dust settling on product, cartons or finished goods after a still weekend.
- Light levels dropping without any fixture failures.
- An audit, insurance walk or fire inspection flagging accumulation on structure.
- Fine residue reappearing on cleaned floors within days.
Methods
How the dust is removed
Method is selected by residue type and what sits underneath:
Vacuum capture
HEPA-filtered extraction at the surface where dust cannot be allowed to fall.
Compressed air blow-down
Used only where the area below can be isolated and cleaned afterwards.
Extension and pole work
Reaching from floor level where clearance and layout allow.
Damp wiping
For sticky or oily film that dry methods will not release — see structural steel cleaning.
Protection
Covering product, equipment and open conveyors before work starts.
Floor follow-up
Scrubbing below once overhead is complete.
Access
Access is the biggest cost driver
High-access work may require lifts or other access equipment depending on the facility and scope. Clear height, aisle width, rack spacing, slab condition and obstructions determine what can travel through the building and how often it has to reposition — and repositioning, not cleaning, is where most of the time goes.
Access requirements are evaluated during project planning. Site-specific requirements are reviewed before mobilization.
Operations
Occupied versus empty buildings
Occupied
- Bay-by-bay release with the area below cleared or covered.
- Capture methods favoured over blow-down.
- Often run on nights or weekends.
Empty or down
- Straight lift runs down open aisles.
- Faster methods available with the floor cleaned afterwards.
- Frequently combined with warehouse cleaning or a full reset.
Questions
High Dusting questions we get asked
Industries served
Related services
Get high dusting scoped properly.
Have a facility that needs more than routine cleaning? Tell us the condition, the constraints and the timeline, and we'll review the scope.